Oxy-Acetylene Cutting Pressure Chart

Oxy-Acetylene Cutting Pressure Chart – Cutting data charts are intended as a guide for quality cutting. If you have a cylinder cart, place. Manufacturers recommended pressure settings for welding, cutting and heating for oxygen and acetylene oxygen and acetylene cutting plate thickness mm. The above data applies to all torches with the following exceptions:

Oxy Acetylene Cutting Pressure Chart

The oxygen pressure typically ranges from 30 to 40 psi (pounds per. One standard size g acetylene cylinder (1/7 rule). Proper gas pressure settings are crucial for achieving clean and efficient cuts.

Pressures Shown Are For 25 Ft (7.6 M) Or Less Of 3/8 In.

Tip size numbers vary among. *** all pressures are measured at the pressure regulator with a 3/8 inch, 25 feet long hose. Selecting the correct welding attachment/ nozzles.

Tables Show Approximate Gas Pressures For Welding Or Cutting.

Increase pressures if longer hose is used. These speeds and pressure settings apply only to. Size cutting oxy fuel thickness pressure pressure mm kpa kpa 6290 000 0.

Then The Cutting And Gouging Processes Can Begin To Remove The Metal.

First, preheat the steel to its kindling temperature. Victor® mthp high speed machine cutting note: When the steel becomes “cherry red”, the added oxygen.

Welding.xls Oxygen & Acetylene Gas Pressures Welding Cutting Notes:

Ensure never to exceed 15 psi for acetylene. Oxy acetylene heating tip (043013) part no. Cutting oxygen adjustment procedure set supply pressure for cutting oxygen pressure at supply regulator to approximately 90 psi adjust cutting oxygen pressure on hi/low.